Hello everyone, I believe many netizens don’t understand the fiberglass slide, including the repair process of the fiberglass slide, but it doesn’t matter. Next, I will share with you about the fiberglass slide and You can pay attention to the collection of some knowledge points about the fiberglass slide repair process, so as not to find it next time. Let’s get started!
Contents of this article
1. What is FRP
1. Glass fiber reinforced resin matrix composite material Commonly known as fiberglass; also known as fiberglass reinforced plastics (FiberReinforcedPlastics), it is a type of composite material with relatively mature technology and the most widely used technology.
2. This material is compounded by using chopped or continuous fibers and their fabrics to reinforce a thermosetting or thermoplastic resin matrix.
3. Transportation: various accessories for passenger cars, trucks, refrigerated trucks, and tank trucks;
4. ■Construction: Building exterior wall panels, transparent corrugated panels, translucent sandwich structural panels, etc. are mainly used for skylights and roof lighting of industrial plants, agricultural greenhouses, and large public buildings
5. ■Chemical industry: pipes for wastewater treatment systems, storage and transportation of chemical materials such as hydrochloric acid
6. ■Construction machinery : Hoisting machinery, transportation machinery, engineering machinery, etc.;
7. ■Mechanical and electrical appliances: insulated instruments, motors and accessories in various electrical appliances;
7. p>
8. Electronic industry: communication transceiver equipment, radome; printed circuit boards, insulation boards, etc.
9. ■Medical devices: composite teeth, bones, respirators, stents, prostheses and other medical devices used in trauma surgery
10. ■National defense industry: anti-tank missile warhead casings, engine casings, rocket nozzles, etc.; aircraft parts
11. ■Aviation Aerospace: ground radome, airborne radome, shipborne radome, vehicle radome, etc.; artificial satellites, space stations and space-to-ground transportation systems, etc.
12. ■Sports and recreational facilities: kayaks, rowing boats, boat slides, sailboats, windsurfing boards, surfboards and other sports equipment; recreational vehicles, recreational boats, water slides, speed slides, bumper cars, children\’s slide recreational facilities
2. Fiberglass slide repair process
Trim and smooth the damaged area with a ring Brush the oxy resin once and stick a layer of glass fiber cloth on it. Repeat several times. It is best to stick it on both sides. Use resin and fiberglass filaments to repair with fiberglass. First, sand the damaged area smooth and rough. Then repair it with resin and fiberglass. The effect after repair depends on the skill level of the repair person. If a part is broken, I personally recommend replacing the part directly. After all, it is too troublesome to repair.
3. The origin of the slide
The first generation of slides is Products from the 1970s had fiberglass tops and cheap square or round tubes for their frames, which were welded and then painted. The top and frame parts were drilled and directly connected with ordinary iron wires. The glass fiber reinforced plastic of this kind of slide is single-layered. It is smooth on the outside and rough on the inside. If a child plays in it, the exposed skin will itch. The iron part: the aisle is only 40-60cm, which is relatively narrow. It is also quite weak and not very safe, so this product has been eliminated.
This ends the introduction of fiberglass slides and fiberglass slide repair procedures. I hope it will be helpful to everyone.
